This command bar is available when creating a reference plane with the By 3 Points, Normal to Curve, and Tangent commands.

• Active command

  Lists the active command.

• Keypoints

  Sets the type of keypoint you can select. This allows you to define the plane position using a keypoint on other existing geometry. The available keypoint options are specific to the command and workflow you use.

  	Allows you to select any keypoint.
  	Allows you to select an end point.
  	Allows you to select a midpoint.
  	Allows you to select the center point of a circle or arc.
  	Allows you to select a tangency point on an analytic curved face such as a cylinder, sphere, torus, or cone.
  	Allows you to select a silhouette point.
  	Allows you to select an edit point on a curve.