Width
Specifies the width of the slot.
Radius
Specifies the radius applied to concave sharp corners on the slot.
Cap Type
Displays the available cap type options.
Line
Specifies that the cap type be a line.
Cap Fillet Radius
Specifies the radius applied to flat cap corners. This option is available only when the Cap Type is set to Line.
Arc
Specifies that the cap type be an arc.
Offset Arc
Specifies that the cap type be an offset arc.
Apply Radii if Fillet Radius = 0
Allows you to turn off the radii if the fillet radius is set to zero, which will result in sharp convex corners.
Show This Dialog When The Command Begins
Displays the dialog box every time you select the command. If you do not want to display the dialog box when you select the command, clear this option.