Displays the type of the selected element. You cannot edit the type.

Displays the name of the drawing sheet the element is on. You cannot edit the name of the drawing sheet.

Sets the layer the element is on. This option is available only in the Draft environment.

Sets the x and y values for the center point of a closed element. Values are relative to the current user defined origin of the sketch that owns the geometry.

Sets a value for the x coordinate. You can use this option by itself or with the Y option.

Sets a value for the y coordinate. You can use this option by itself or with the X option.

Sets the length of the primary axis. The ellipse orientation is based on the primary axis.

Sets the length of the secondary axis. The secondary axis is perpendicular to the primary axis.

Sets the angle of the primary axis of the ellipse. Zero degrees is horizontal to the x axis. The angle increases in the counterclockwise direction.

Displays the circumference of a closed element. Although you cannot edit the circumference, the box automatically updates when you edit the geometry.

Displays the area of a closed element. Although you cannot edit the area, the box automatically updates when you edit the geometry.